California / Sacramento County

Patio Permit in Sacramento County, California

It depends

Sometimes, depending on the project

Before building any attached patio cover, porch or enclosure, and before building a detached cover larger than 200 square feet, taller than 12 feet, or closer than 5 feet to a property line.

Confirmed on official page Verified Sacramento County Community Development, Building Permits and Inspection Division

By Mario Bailey, verified against official sources

Quick answer

The exemption only reaches detached, open patio covers: 200 square feet or less, not fully enclosed, no more than 12 feet tall measured from adjacent grade to the highest point of the roof, and 5 feet or more from the property line. Anything attached to the house is outside that carve-out, and the FAQ lists "Patio Cover, Porch, Enclosure" among projects that require a permit. Permitted patio work goes through plan review, and enclosing a patio pulls in extra review of adjacent rooms and emergency escape windows.

Typical threshold: floor area of a detached, not fully enclosed patio cover, pergola, arbor or trellis that is also no taller than 12 feet and stands 5 feet or more from the property line.

Diagram of the 200 sq ft footprint area threshold for a patio permit in Sacramento County, California
Threshold illustrated: 200 sq ft. Whether Sacramento County requires a permit above or below this measurement is stated in the verdict on this page, verified 2026-08-15.

Who is pulling this permit?

Hire it out

Before you sign, ask the contractor:

  • Who pulls the permit, you or me, and is the permit fee included in the bid?
  • Which inspections will this job need, and who meets the inspector on site?
  • Is your contractor license active in this locality, and under which business name?

When a permit is usually needed

Before building any attached patio cover, porch or enclosure, and before building a detached cover larger than 200 square feet, taller than 12 feet, or closer than 5 feet to a property line.

What a patio permit costs in Sacramento County

Line item
patio permitBy formulaNo patio cover line item is published. Sacramento County posts no building permit fee schedule PDF; its Fees and Exactions page links "Permit Fees" to Sacramento County Code Chapter 16.90, Construction Permit Fees, on ecode360, which returns HTTP 403 to automated requests, so no dollar figures were transcribed. Fees are calculated and paid in the Accela Citizen Access portal at application, plus the Technology (IT) Cost Recovery Fee under County Code Section 16.140.010.
Fee schedule in forceOfficial scheduleRead . Fees are the jurisdiction’s; we do not mark them up or estimate them.

How Sacramento County compares in California

Across the California jurisdictions we have verified, the same threshold runs from 120 to 300, so a project that is exempt here may still need a permit one county over.

JurisdictionPermit needed?Threshold
Alameda CountyIt dependsTotal area of each sunshade structure, including any roofed area, at which the building permit exemption stops; the exemption also requires an average height of not more than 10 feet
Contra Costa CountyIt dependsroof area of a trellis, arbor, or pergola accessory to a residence, treated by the county as a one-story detached accessory structure
Fresno CountyPermit requiredNot specified
Los AngelesPermit requiredNot specified
Los Angeles CountyIt dependsNot specified
Sacramento Countythis pageIt dependsfloor area of a detached, not fully enclosed patio cover, pergola, arbor or trellis that is also no taller than 12 feet and stands 5 feet or more from the property line
San DiegoIt dependspatio cover accessory to a dwelling under 300 sq ft of projected roof area and no taller than 12 ft and not in a yard setback does not require a permit

Closest patio permit thresholds outside California

Jurisdictions we cover whose limit sits nearest Sacramento County's 200 sq ft.

  • Corpus Christi, Texas, Every attached patio cover or carport needs a permit regardless of size; a detached patio cover or carport needs one once it is larger than 200 square feet.
  • Dallas, Texas, detached patio covers of 200 sq ft or less on single-family or duplex premises are exempt; attached patio covers and those over 200 sq ft require a permit
  • Eugene, Oregon, roofed patio or porch cover supported by an exterior building wall
  • Gilbert, Arizona, Only one-story detached non-habitable accessory structures up to 200 square feet are exempt from permit; attached patio covers and larger structures require a building permit.

How to apply in Sacramento County

Applying for a patio permit means submitting a site plan and framing plans for a roofed patio cover, since a cover is treated as its own permitted structure regardless of size. A plain concrete or paver patio slab at or near grade is, by contrast, often exempt from that same building permit requirement.

What most patio permit applications include:

  • Filing a permit application with the local building department, which only the property owner or an authorized agent may sign, since a patio cover is treated as its own permitted structure regardless of size (IRC R105.1).
  • A scaled site plan showing the new patio cover's size and location relative to the house and other existing structures, with dimensioned distances to all property lines so required setbacks can be verified before the permit is approved (IRC R106.2).
  • Construction documents such as a framing plan and elevation, showing rafter or beam sizes and spacing, the distance between supporting posts, and the method of attachment to the house, drawn with enough clarity for the building official to confirm the work will conform to the code (IRC R106.1).
  • For the roof structure itself, plans showing compliance with the patio cover appendix's structural limits, such as adequate footing sizes for the applied post loads, since a shallow slab on grade may substitute for a deeper footing only in limited cases up to about 750 pounds of load per post (IRC Appendix AH, Section AH105.2).
  • By contrast, an at grade concrete or paver patio that is not attached to the dwelling and stays within the code's small flatwork thresholds, similar to a sidewalk, driveway, or low deck under 200 square feet and 30 inches high, commonly needs no building permit at all, so none of the plan review steps above apply (IRC R105.2).

General submittal guidance from 2021 International Residential Code (IRC), Sections R105 and R106, with Appendix AH Patio Covers (named Appendix H in the 2012, 2015, and 2018 editions). Source. Sacramento County Community Development, Building Permits and Inspection Division sets the exact checklist for Sacramento County.

Where to apply in Sacramento County:

Sacramento County Community Development, Building Permits and Inspection Division

  • Building Assistance Center, 9800 Goethe Road, Sacramento, CA 95827
  • Phone: 916-875-5296
  • Email: rudolphr@saccounty.gov

Inspections and closing out your permit

A permitted patio cover follows the same footing, frame, and final inspection sequence used for any small accessory structure, since the posts and roof framing have to be checked before they are covered and again once the work is done. An at grade patio slab that qualifies as exempt flatwork usually needs no building inspection at all, because inspections only attach to work that required a permit in the first place.

  1. A footing inspection once the excavation, forms, and any reinforcing steel are in place but before concrete is poured, confirming the posts supporting a patio cover will bear on adequate footings (IRC R109.1.1).
  2. A frame inspection after the rafters, beams, posts, and any required rough in work are in place but before the roof sheathing or covering material conceals them, since a solid patio cover roof cannot be signed off once it is covered without this check (IRC R109.1.4).
  3. A final inspection once all permitted work, including roofing and post anchorage, is complete, which the code requires before the structure may be used (IRC R109.1.6).
  4. An at grade concrete or paver patio that qualifies as exempt flatwork under the permit rules is not subject to any of these inspection stages, since the inspection sequence only attaches to work that required a permit in the first place (IRC R105.2).
  5. Each inspection has to be requested by the permit holder rather than happening automatically, and the approved plans and permit card need to be on site and available when the inspector arrives (IRC R109.3).

Schedule each inspection in advance and pass the final before you use the work or close the permit. Request inspections through the Sacramento County permit portal or by phone at 916-875-5296.

Inspection sequence from 2021 International Residential Code (IRC), Section R109 (Inspections). Source. An open permit left un-inspected can surface later in a title search or home sale.

Frequently asked questions

Do you need a patio permit in Sacramento County?
The exemption only reaches detached, open patio covers: 200 square feet or less, not fully enclosed, no more than 12 feet tall measured from adjacent grade to the highest point of the roof, and 5 feet or more from the property line. Anything attached to the house is outside that carve-out, and the FAQ lists "Patio Cover, Porch, Enclosure" among projects that require a permit. Permitted patio work goes through plan review, and enclosing a patio pulls in extra review of adjacent rooms and emergency escape windows. Floor area of a detached, not fully enclosed patio cover, pergola, arbor or trellis that is also no taller than 12 feet and stands 5 feet or more from the property line. Always confirm with the office before starting.
How much does a patio permit cost in Sacramento County?
No patio cover line item is published. Sacramento County posts no building permit fee schedule PDF; its Fees and Exactions page links "Permit Fees" to Sacramento County Code Chapter 16.90, Construction Permit Fees, on ecode360, which returns HTTP 403 to automated requests, so no dollar figures were transcribed. Fees are calculated and paid in the Accela Citizen Access portal at application, plus the Technology (IT) Cost Recovery Fee under County Code Section 16.140.010. See the official fee schedule for current amounts.
Where do you apply for a patio permit in Sacramento County?
You can apply through the Sacramento County permit portal or contact the Sacramento County Community Development, Building Permits and Inspection Division directly. The links are listed on this page.
Can a homeowner pull a patio permit themselves in Sacramento County?
Under California law (Business & Professions Code 7044(a)-(b); Business & Professions Code 7031.5): California exempts an owner-builder from contractor licensing when the owner personally performs the work, or uses only wage employees, on their own property and does not intend the improvements for sale. A homeowner may also directly hire licensed trade contractors for up to four single-family residences a year, or improve their own principal residence without a general contractor's license, as long as they have actually lived there for the 12 months before the work is finished. Selling a self-built structure within one year of completion creates a rebuttable presumption that it was built for sale, which defeats the exemption, and selling five or more structures within a year makes that presumption conclusive. Separately, every city or county that requires a building permit must also require the applicant to file a signed statement giving their contractor license number or the basis of their claimed exemption; a false or missing statement carries a $500 civil penalty. Confirm how Sacramento County applies this before you apply.

From the Library

What else needs a permit in Sacramento County

Every other permit type we have verified for this jurisdiction, with the rule that applies here.

ProjectPermit needed?ThresholdTypical fee
Deck PermitIt dependsdeck area, where the deck is also no more than 30 inches above grade at any point, is not attached to a dwelling, and does not serve a required exit doorNo deck line item is published.
Electrical PermitPermit requiredNot specifiedNo electrical line item is published.
Fence PermitIt dependsfence height, measured from the grade on the right-of-way side when the fence sits within 5 feet of the public right-of-way and otherwise from the highest grade on either sideNo fence line item is published.
HVAC PermitPermit requiredNot specifiedNo heating and cooling line item is published.
Plumbing PermitPermit requiredNot specifiedNo plumbing line item is published.
Pool PermitIt dependsdepth of water the structure holds; the permit exemption is limited to prefabricated poolsNo pool line item is published.
Roof Replacement PermitPermit requiredNot specifiedNo re-roof line item is published on the current site.
Shed PermitIt dependsfloor area of a one-story detached structure designed for storage with no electrical or plumbing installedNo shed line item is published.
Solar PermitPermit requiredNot specifiedThe county publishes no dollar amount for a residential solar permit, but the SolarAPP+...

Patio Permit in other California localities

Everything above, sourced

Code references

National and state model-code sections the general guidance on this page is drawn from. They are not Sacramento County documents; the office above sets the local rules.

Verified by a person against the sources above on , not confirmed with Sacramento County Community Development, Building Permits and Inspection Division. Rules change; confirm before you build. How we verify.

Last checked: Report an error on this page

Compare Patio Permit requirements across California localities

It depends
Get quotes