Florida / Broward County

Patio Permit in Broward County, Florida

By Mario Bailey Last checked 2026-06-18 · 2 official sources

Verified against official sources Confirmed on official page

Permit required

Quick answer

A building permit is required for patio slabs in unincorporated Broward County. Driveways and patio slabs are listed as a permit category on the official Building Code and Permits forms page. Minimum slab thickness and reinforcement standards apply under the Florida Building Code. This requirement applies in the Broward Municipal Services District (BMSD).

Who is pulling this permit?

Hire it out

Before you sign, ask the contractor:

  • Who pulls the permit, you or me, and is the permit fee included in the bid?
  • Which inspections will this job need, and who meets the inspector on site?
  • Is your contractor license active in this locality, and under which business name?
Want a pro to handle this permit? Request free help

Tell us where your project stands. Free to ask; no obligation.

Where we have a vetted local pro who handles permits in Broward County, we connect you; otherwise we reply with the exact steps and office links for your situation. PermitNotebook is not a government agency and does not file permits. This is a free referral request; we may earn a fee if you hire a pro we introduce. Partners never influence our permit data. Privacy policy.

When a permit is usually needed

Before pouring any concrete patio slab

What your patio permit must meet in Florida

Florida covered patios and screened patios or lanais are built under the Florida Building Code, Residential, 8th Edition (2023), which uses its own patio-cover appendix with wind load as the governing design criterion, while aluminum-frame screen enclosures are engineered under the wind-load provisions of the Florida Building Code, Building.

  • Patio covers are governed by the FBC Residential patio-cover appendix; in the 8th Edition its design-loads section was revised to remove the snow-load reference, leaving wind load as the governing design criterion statewide (FBC-R Appendix H, AH105.1).
  • Wind loads for screen enclosures are not calculated under the normal building wind-load method; they must be determined under Florida Building Code, Building, Section 2002.4 instead, per an express exception in Section 1609.1.1 of the current code (FBC-B 1609.1.1, 2002.4).

Based on Florida Building Code, Residential, 8th Edition (2023), Appendix H (AH105.1); Florida Building Code, Building, 8th Edition (2023), Sections 1609.1.1 and 2002.4. Read the code. Local amendments can be stricter; confirm the current requirement with your office before you build.

What patio permit costs in Broward County

No separate patio fee line; patios fall under the Structural permit schedule, the greater of a $125 minimum base fee or 3.0% of job value, per Section 40.29 (Ord. 2025-038, eff. 5-1-25).

Official fee schedule

How Broward County compares in Florida

JurisdictionPermit needed?Threshold
Broward Countythis pagePermit requiredNot specified
Lee CountyIt dependsA permit is required to construct, enlarge, alter, or repair a structure, including structural slabs, unenclosed structures, porches, and screen, glass, or vinyl rooms; the county refers residents to Florida Building Code 105.2 and Land Development Code 6-117 for work not requiring a permit.
Miami-Dade CountyIt dependsopen concrete slabs and pavers outside the building do not require a building permit; roofed or screened patio enclosures require a permit
Orange CountyPermit requiredNot specified
Palm Beach CountyIt dependsNot specified
Pasco CountyIt dependsNon structural concrete flatwork under 500 square feet per parcel that will not be built on is exempt outside special flood hazard areas; slabs intended for a future structure require a permit with sealed plans.
Pinellas CountyPermit requiredNot specified

How to apply in Broward County

Applying for a patio permit means submitting a site plan and framing plans for a roofed patio cover, since a cover is treated as its own permitted structure regardless of size. A plain concrete or paver patio slab at or near grade is, by contrast, often exempt from that same building permit requirement.

What most patio permit applications include:

  • Filing a permit application with the local building department, which only the property owner or an authorized agent may sign, since a patio cover is treated as its own permitted structure regardless of size (IRC R105.1).
  • A scaled site plan showing the new patio cover's size and location relative to the house and other existing structures, with dimensioned distances to all property lines so required setbacks can be verified before the permit is approved (IRC R106.2).
  • Construction documents such as a framing plan and elevation, showing rafter or beam sizes and spacing, the distance between supporting posts, and the method of attachment to the house, drawn with enough clarity for the building official to confirm the work will conform to the code (IRC R106.1).
  • For the roof structure itself, plans showing compliance with the patio cover appendix's structural limits, such as adequate footing sizes for the applied post loads, since a shallow slab on grade may substitute for a deeper footing only in limited cases up to about 750 pounds of load per post (IRC Appendix AH, Section AH105.2).
  • By contrast, an at grade concrete or paver patio that is not attached to the dwelling and stays within the code's small flatwork thresholds, similar to a sidewalk, driveway, or low deck under 200 square feet and 30 inches high, commonly needs no building permit at all, so none of the plan review steps above apply (IRC R105.2).

General submittal guidance from 2021 International Residential Code (IRC), Sections R105 and R106, with Appendix AH Patio Covers (named Appendix H in the 2012, 2015, and 2018 editions). Source. Broward County Building Code Division sets the exact checklist for Broward County.

Where to apply in Broward County:

Broward County Building Code Division

  • 2307 W Broward Blvd Suite 300, Fort Lauderdale, FL 33312
  • Phone: (954) 765-4400
  • Email: building@broward.org

Inspections and closing out your permit

A permitted patio cover follows the same footing, frame, and final inspection sequence used for any small accessory structure, since the posts and roof framing have to be checked before they are covered and again once the work is done. An at grade patio slab that qualifies as exempt flatwork usually needs no building inspection at all, because inspections only attach to work that required a permit in the first place.

  1. A footing inspection once the excavation, forms, and any reinforcing steel are in place but before concrete is poured, confirming the posts supporting a patio cover will bear on adequate footings (IRC R109.1.1).
  2. A frame inspection after the rafters, beams, posts, and any required rough in work are in place but before the roof sheathing or covering material conceals them, since a solid patio cover roof cannot be signed off once it is covered without this check (IRC R109.1.4).
  3. A final inspection once all permitted work, including roofing and post anchorage, is complete, which the code requires before the structure may be used (IRC R109.1.6).
  4. An at grade concrete or paver patio that qualifies as exempt flatwork under the permit rules is not subject to any of these inspection stages, since the inspection sequence only attaches to work that required a permit in the first place (IRC R105.2).
  5. Each inspection has to be requested by the permit holder rather than happening automatically, and the approved plans and permit card need to be on site and available when the inspector arrives (IRC R109.3).

Schedule each inspection in advance and pass the final before you use the work or close the permit. Request inspections through the Broward County permit portal or by phone at (954) 765-4400.

Inspection sequence from 2021 International Residential Code (IRC), Section R109 (Inspections). Source. An open permit left un-inspected can surface later in a title search or home sale.

Permitting activity in Broward County

In 2024, Broward County authorized permits for 1,655 new residential housing units (697 single-family, 958 in multi-family buildings), valued at $409M, down from3,047 the year before. That works out to about 0.8 permits per 1,000 residents.

Source: U.S. Census Bureau, Building Permits Survey, 2024 annual data · population 2,037,472.

About Broward County

Broward County has about 863,128 housing units. The median home is valued at $380,400, against a median household income of $74,534. About 63% of homes are owner-occupied, and the typical home was built around 1980.

Source: U.S. Census Bureau, American Community Survey 2023 5-year.

Frequently asked questions

Do you need a patio permit in Broward County?
A building permit is required for patio slabs in unincorporated Broward County. Driveways and patio slabs are listed as a permit category on the official Building Code and Permits forms page. Minimum slab thickness and reinforcement standards apply under the Florida Building Code. This requirement applies in the Broward Municipal Services District (BMSD). Always confirm with the Broward County Building Code Division before starting.
How much does a patio permit cost in Broward County?
No separate patio fee line; patios fall under the Structural permit schedule, the greater of a $125 minimum base fee or 3.0% of job value, per Section 40.29 (Ord. 2025-038, eff. 5-1-25). See the official fee schedule for current amounts.
Where do you apply for a patio permit in Broward County?
You can apply through the Broward County permit portal or contact the Broward County Building Code Division directly. The links are listed on this page.

From the Library

What else needs a permit in Broward County

Every other permit type we have verified for this jurisdiction, with the rule that applies here.

ProjectPermit needed?ThresholdTypical fee
Deck PermitPermit requiredNot specifiedNo separate deck fee line;
Electrical PermitPermit requiredNot specifiedElectrical permit is the greater of a $125 minimum base fee or 3.0% of job value, per S...
Fence PermitPermit requiredNot specifiedNo separate fence fee line;
HVAC PermitPermit requiredNot specifiedMechanical (air conditioning and ventilation) permit is the greater of a $125 minimum b...
Plumbing PermitPermit requiredNot specifiedPlumbing permit is the greater of a $125 minimum base fee or 3.0% of job value, per Sec...
Pool PermitPermit requiredNot specifiedPool work needs separate Structural, Plumbing, Mechanical and Electrical permit applica...
Roof Replacement PermitIt dependsunder F.S. 553.79(1)(g) (HB 803, ch. 2026-63, effective 2026-07-01), work valued at less than $7,500 on a single-family dwelling qualifies for exemption upon a written exemption request with documentation of the nature and value of the work; the exemption excludes electrical, plumbing, structural, mechanical, and gas work and any property in a flood hazard area; the statute does not name roofing, so a non-structural reroof under that value can qualify; confirm with Broward County Building Code Division.Structural permit with a roofing-specific minimum: the greater of a $250 minimum base r...
Shed PermitPermit requiredNot specifiedNo separate shed fee line;
Solar PermitPermit requiredNot specifiedNot published

Patio Permit in other Florida localities

Official sources

Verified by a person against the sources above on 2026-06-18, not confirmed with Broward County Building Code Division. Rules change; confirm before you build. How we verify.

Last checked: 2026-06-18Report an error on this page

Compare Patio Permit requirements across Florida localities