Guide
Do You Need a Permit to Repipe a House?
A whole-house repipe needs a plumbing permit almost everywhere, because the model code treats replacing pipe as new work, not repair. Indianapolis exempts in-kind replacement of up to 20 percent of the piping. What a repipe permit costs where we read it, the pressure test, and the grounding problem when copper becomes PEX.
Yes, almost everywhere. Replacing the water pipes in a house is plumbing work that needs a permit, even though fixing a leak usually does not. The model code draws the line in one sentence: you may stop a leak without a permit, but once pipe has to be removed and replaced with new material, “such work shall be considered as new work and a permit shall be obtained”. A whole-house repipe is the clearest case there is. The permit is usually a simple trade permit, often available online. In Santa Clara County, California, the permit fee is $719.00, or $801.00 when the job includes drywall or shear wall repair, plus the county’s 3% information technology fee ($740.57 or $825.03 with that fee).
- Permit for a whole-house repipe
- Yes, a plumbing permit
- Leak repair
- Usually no permit, until pipe is replaced
- Partial repipe exemption
- Indianapolis: in-kind, up to 20% of the piping
- Fee we read
- $719.00, or $801.00 with drywall or shear repairSanta Clara County, FY 2026-27, plus a 3% technology fee
- Watch for
- Electrical grounding, if the old metal pipe grounded the panel
Before anyone opens a wall, ask your plumber who pulls the permit and whether the quote includes it, and ask them one more question: “Is our electrical system grounded to the water pipe, and if so, what will you do about it?”
Repair or new work: where the line is
The residential code’s list of work exempt from a permit has two plumbing items. Rhode Island prints the state version word for word:
“The stopping of leaks in drains, water, soil, waste or vent pipe; provided, however, that if any concealed trap, drainpipe, water, soil, waste or vent pipe becomes defective and it becomes necessary to remove and replace the same with new material, such work shall be considered as new work and a permit shall be obtained and inspection made as provided in this code.”
“The clearing of stoppages or the repairing of leaks in pipes, valves or fixtures, and the removal and reinstallation of water closets, provided such repairs do not involve or require the replacement or rearrangement of valves, pipes or fixtures.”
So a clamp on a pinhole leak is a repair. Cutting out a failed section of pipe and replacing it is new work under this wording. Replacing the supply piping of the whole house is new work everywhere this wording is in force.
The exception: a percentage rule. Indianapolis allows “Replacement in kind of piping in a plumbing system when the replacement piping meets the same performance specifications and has the same capacity as the piping being replaced. It must not be more than 20 percent of all piping in the structure being replaced”. A partial repipe there, in the same material and size, can be done without a permit up to that share. A whole-house repipe, or a switch from copper to PEX, which is not in kind, cannot.
How offices permit a repipe
A repipe almost never needs plans. Offices handle it as one of their quickest trade permits.
- Clark County, Nevada, lists “Re-Pipe (Residential Only)” among its Simple Online Permits for plumbing, one item per permit.
- Unincorporated Riverside County puts single-family re-pipes on its mandatory self-certification list, filed through the public portal and signed off by a licensed contractor (from the county’s plumbing rule as verified in our dataset).
- Tampa issues a water distribution re-pipe inside the house on a plumbing trade permit without plan review, and Miami lists “RE-PIPING OR REPAIRS” among its plumbing easy permits for qualified contractors.
- Pinellas County, Florida, inspects an interior-only repipe virtually: the contractor, or the homeowner who pulled the permit, submits the report and pictures through an inspection app.
Where the repipe means opening walls, the plumbing permit may not be the only one. Milpitas, California, says “Extensive removal of the walls or ceiling structure requires a building permit.” Santa Clara County prices that difference: its Re-Pipe or Re-Wire line is $719.00, or $801.00 where the job includes “Gyp or Gyp and Shear Repair”, meaning drywall patching or repairs to shear walls, and the schedule marks the 3% information technology fee as applying to both.
Other fees we have read: our plumbing permit index lists the plumbing fee each office publishes, with the date we read it.
What the inspector checks
The pressure test. Milpitas, under the California Plumbing Code, section 609.4: the new system “shall be tested with water or air”. “The potable water test pressure shall be at least equal to the working pressure under which the system is to be used. The air pressure shall be a minimum of 50 psi. Plastic pipe shall not be tested with air,” and the system must hold “for a period of not less than 15 minutes.” Your office may use a different code edition with different numbers. Ask when the test is inspected, and do not let anyone close a wall before it has passed.
Supports, insulation and penetrations. Pinellas County’s virtual inspection asks to see piping in the attic “to verify proper support and insulation”, pipe in the wall openings, the depth and insulation of any buried pipe, shut-off valves at every fixture and vacuum breakers on new hose bibbs.
Grounding. This is the item homeowners do not see coming. In many older houses the metal water pipe is part of the electrical grounding system. Replace it with plastic and that path is gone. Pinellas County’s inspector must see “the existing grounding source for the electrical panel and / or meter,” and “If the existing grounding was utilized by metallic pipe and replaced or interrupted by nonmetallic pipe an electrical grounding letter will need to be provided by a licensed electrical contractor.” Milpitas cites the same rule (CPC 604.10): metal piping used for grounding may be replaced with plastic only where a grounding system acceptable to the building official “is installed, inspected, and approved”. Budget for an electrician’s visit if your house is grounded this way.
Items at the final that have nothing to do with pipes. In Milpitas, the final inspection of any permit at a one- or two-family house checks smoke and carbon monoxide alarms, and the city also requires noncompliant plumbing fixtures to have been replaced with water-conserving ones under California Civil Code section 1101. Ask your office what its final inspection includes before you schedule it.
Who may pull the permit
Many offices require a licensed plumber for a repipe; some let an owner-occupant pull a plumbing permit for their own house. Milpitas, for example, issues the permit to the owner or the owner’s authorized agent, and an owner who hires workers must carry workers’ compensation insurance. Our guide to plumbing work that needs a permit covers who may pull plumbing permits, and the guide to who pulls the permit covers why the contractor usually should.
Before the plumber starts
- Get the permit number before work begins, and see the permit card posted on site.
- Ask whether your electrical service is grounded through the water pipe. If it is, get the electrician’s fix into the same schedule.
- Ask how many wall openings the job needs and who patches them. If the office requires a building permit for the wall work, the plumber or a separate contractor must pull it.
- Be home, or have the plumber send you the result, for the pressure test inspection, before any wall is closed.
- Keep the finaled permit. If the house had old galvanized or polybutylene pipe, the permit is the proof it was replaced and inspected.
Method
This guide rests on six documents read on November 18, 2026: the Rhode Island code, the Indianapolis, Clark County, Santa Clara County and Milpitas pages, and the Pinellas County inspection instructions. Quotes are copied from them, and the technology fee totals are our arithmetic on the Santa Clara schedule. The Riverside County, Tampa and Miami entries are cited from the plumbing permit rules verified in our dataset; their pages on this site show when each was last read.
Do You Need a Permit to Repipe a House?: figures as of 28 Sep 2026, 137 jurisdictions. Now 178.
Sources
- Rhode Island State One and Two Family Dwelling Code (510-RICR-00-00-2), the state edition of the residential code: the plumbing items of the work exempt from permit, including the rule that replacing defective pipe is new work. (accessed )
- Indianapolis Department of Business and Neighborhood Services, Residential Development Permits: the plumbing permit exceptions, including in-kind replacement of no more than 20 percent of the piping. (accessed )
- Clark County, Nevada, Building Simple Permits: Re-Pipe (Residential Only) among the plumbing items, one item per permit. (accessed )
- County of Santa Clara, Building Fee Schedule, FY 2026-2027, effective July 18, 2026: Re-Pipe or Re-Wire, $719.00, or $801.00 with gyp or gyp and shear repair, with the 3% information technology fee marked as applying. (accessed )
- City of Milpitas Office of Building Safety, Water Piping (Residential) handout, dated 01/01/2026: permit requirement, wall removal, testing under CPC 609.4, replacement of metal piping used for grounding (CPC 604.10), and the items checked at final. (accessed )
- Pinellas County, Offline Report Inspection Instructions, Repipe Water Distribution, Interior Only (03-2026): what the inspector must see, including the grounding source and the electrical grounding letter. (accessed )
Get rule-change alerts
We catch permit rule and fee changes in our verification passes and post them to the rule tracker. Get them by email instead.
We may send occasional verified rule-change notes for your area; unsubscribe anytime. See our privacy policy.